Hydra Tool EMMC Tab "Drive Not Ready Error" Solution

techy147

Member
Jun 14, 2020
45
3
Space
Hello, as many users face "Drive Not Ready" error on Emmc Tab this is the possible solution for the error.

277106390-3176464862639104-4913225173751146398-n.jpg


Basically its because of old emmc hardware need modification to be able to connect with Newer emmc chips.
You have to add two pull-up resistors as show in the below image.


emmc-1.jpg



If your Adaptor already has red switch box then its already modified just make sure that switches are towards on side.