Dear ufixers new setup is great update but there some bugs like
every emmc helth Showing there Device lifetime Not Defined
please solve them
emmc helth report
Serial number: 0011-8842-8108
Boot version: 1.05, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 3.3 V, VCCQ: 3.0 V
Bus: 1 bit (SDR 52MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x90 (SK Hynix)
Product name: HBG4a2 (0x484247346132), rev: 0xA4, serial number: 0x33B5182B
Manufacturing date: Sep 2016
CID: 90014A48 42473461 32A433B5 182B9372
CSD: D0270132 8F5903FF FFFFFFE7 8A400016
Device version: 0x4205
Firmware version: 0xA4
EXT_CSD revision: 1.8 (MMC v5.1)
Partition info:
Boot1: 4 MiB
Boot2: 4 MiB
RPMB: 4 MiB
User area: 29.12 GiB(31,268,536,320 bytes)
eMMC 5.x Health report:
Device lifetime: Not Defined
Estimation of the device lifetime (SLC): 0% - 10% device life time used
Estimation of the device lifetime (MLC): 30% - 40% device life time used
SK Hynix Health (Smart) report:
Factory bad blocks count in CE0: 0
Run-time bad blocks count in CE0: 0
Factory bad blocks count in CE1: 0
Run-time bad blocks count in CE1: 0
Factory bad blocks count in CE2: 0
Run-time bad blocks count in CE2: 0
Factory bad blocks count in CE3: 0
Run-time bad blocks count in CE3: 0
